Mechanical Splicing / Rebar Couplers
“MECH-JOINT” Mechanical Splices from HI-TECH GROUP are a parallel splicing system that assures a positive locking connection, providing continuity and structural integrity and not dependent on the surrounding quality of concrete in construction.
“MECH-JOINT” spliced bars behave as continuous lengths of reinforcing steel bars by providing “full strength” in tension, compression and stress reversal applications and are TYPE-2 COUPLERS Asper ACI CODES 318-08.
“MECH-JOINT” spliced bars behave as continuous lengths of reinforcing steel bars by providing “full strength” in tension, compression and stress reversal applications and are TYPE-2 COUPLERS Asper ACI CODES 318-08.
Easy to operate and maintain, Highproduction efficiency and fast installation, no need for skilled technicians
Easy to operate and maintain, High-production efficiency and fast installation, no need for skilled technicians
The splices could be produced in advance without influencing the construction period.
The splices could be produced in advance without influencing the construction period.
Our Rebar couplers are based on Globally approved & Patented Parallel threaded mechanism where the material is displaced/aligned to form the roots of threads.
There is no process of removal/area reduction of steel Unlike other threading processes where 20-40% of the steel area & its strength is reduced.
In contrary,there is an increase of strength of the reinforcement to the tune of 15% due to hardening process.
The most effective feature of this system is its ability to withstand higher fatigue strength as the material grains are not removed /disturbed otherhan realigning of material to form threads.Benefits of using”MECH-JOINT” couplers against overlapping of reinforcements.
Avoid Congestion of reinforcement caused due to lapping.
Drastically reduce Consumption of Steel as lapping is avoided and hence scrap generation is minimized.
Avoid Formation of Voids/Honeycombs in structural element due to poor compaction of concrete possibly with dense lapping.
Avoid starter bars/bent-up bars to connect diaphragm walls, pre-cast elements, corewall system etc,.
Avoid staggering of reinforcement incase of our rebar couplers as Coupled bars with rebar couplers act as a continuous/single bar.
No welding of rebars required.
Minimal Power requirements for threading machines
Our Machines can thread min1000 bars per shift hence to Avoid any delay in progress of site.
Onsite inspection by Qualified Technical supervisors to ensure smooth flow of progress.